Posted by andy r on October 18, 2013 at 07:09:07 from (75.91.149.15):
In Reply to: Grain slab size posted by JEH on October 18, 2013 at 05:28:39:
It sounds like what you have is actually a bulk bin since it is 6 feet across with legs?? What I have seen with the bulk bins is to pour a 6" slab of moderately strong concrete extending a foot past the diameter of the sides. When you layout the forms dig holes immediately under where the legs will sit an additional 12 inches, since the weight is going to be concentrated. The holes could be one foot in diameter. Actually you should have a rat barrier around the entire slab, so both could be accomplished by digging a one foot by one foot trench around the slab. That would support the bin and provide rat protection. I would think that would be more than plenty to support the bin. Most 18' - 7 ring grain bins are sitting on a 6" slab with a 1' by 1' trench around the outside under the 6" slab. Fastening the bin down isn't that hard. Done several of them. Set the bin on the hardened concrete to get it centered. Either weld plates to the bottom of the legs with 1/2" holes in them or use 4" wide angle irons and bolt to the leg and concrete. Drill 1/2" holes in the concrete with a concrete bit (not that hard to do - concrete drill helps - cheap at Menards.) Then use concrete anchor bolts. 1/2" reinforcing rod every foot across sideways and then every foot longways would be beneficial as well, not to prevent cracking, but to prevent the concrete from spreading when it does crack. Make sure the re-rod is midway in the slab when the concrete is poured and out of the way were the concrete anchors will be put. Make sure you are pouring on either a soild base or tamped fill. Not that hard - 1/2 a day job.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.