The ONLY time a "high pressure" regulator is used is at the tank, when LOTS of BTU's/gas flow through the underground line from the tank to the building is needed and they MUST be paired with a secondary/low pressure regulator at the building.
Probably NOT gonna happen from a 100lb tank!
I don't know of a single example of a propane appliance that is not rated for 10" to 13" W.C. of pressure.
A single-stage regulator at the tank, or a two-stage/primary/secondary regulator system with a high pressure regulator at the tank and a secondary regulator at the building delivers this standard pressure to the appliance.
Which reminds me of a true story...
A man jumps out of an airplane with a parachute on his back.
As he's falling, he realizes his chute is broken.
He doesn't know anything about parachutes, but as the earth rapidly approaches, he realizes his options are limited; he takes off the parachute and tries to fix it himself on the way down.
The wind is ripping past his face, he's dropping like a rock, and at 5000 feet, another man goes shooting up past him.
In desperation, the man with the chute looks up and yells, "Hey do you know anything about parachutes?!"
The guy flying up looks down and yells, "No, do you know anything about gas stoves?!"
Enuf said... don't mess with this stuff if you don't understand it!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
