Posted by rrlund on October 29, 2013 at 14:01:40 from (207.241.137.116):
I took those front hubs apart on that 85 Ford F250 4x4 last week to check the bearings. Had to take the calipers off to get it apart. They have what looks like a real small I-beam with a little leaf spring that drives in a slot to hold them on. When I took the right side off,that little spring was missing and when I put it together something just didn't seem quite right either.
Fast forward to yesterday. The neighbor and I loaded up a steer and went to the slaughter house. There was a clatter in the front of that truck that sounded like the whole front end was coming out of it. He said it sounded like a hub wasn't unlocked all the way and there must be a U joint going out. By the time we got home,it sounded a lot better. So I loaded up some cull cows this morning and went to the sale barn. Same gawdawful noise.
I got home,crawled underneath,turned the driveshaft and the axles turned OK,hubs were unlocked,U joints looked good,but I could see daylight where that little I-beam piece was supposed to be. The caliper was rattling around on the rotor,hitting the inside of the wheel,banging up against the top of the mount,you name it.
So I figure it's gonna be Ford only for sure. Didn't even go to the auto parts store a mile away.Went to the Ford dealer 12 miles away. They tell me it's obsolete and NLA from Ford. Came home and went to the auto parts store,yep,they've got them in the warehouse,be here in the morning.
Just when you think you know what will be dealer only.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.