Posted by oldtanker on November 02, 2013 at 21:04:12 from (66.228.255.116):
In Reply to: American ingenutiy posted by wilson ind on November 02, 2013 at 15:56:13:
Quoting Removed, click Modern View to see
Wilson, you can buy a scan tool setup that is a software/hardware package and hooks up to your PC. Cost about 130 bucks. Don't take many trip to the shop for a scan to pay for it.
Edd in KY: Check your facts. We have been outsourcing sense WWII ended. We sent troops to China over 110 years ago to protect American missionaries and American business interest. This isn't a 20 year old problem. And the politicians didn't send those jobs overseas, the consumer did in the drive for cheap goods on the store shelves. Sure some jobs were sent overseas in the last 20 years because of the EPA and OSHA, but not as many as disappeared due to consumer demand.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.