The roof does not have a manhole to get inside. The next section of roof to the right of the ladder has a bolt with a wingnut at the bottom to hold it in place. You must remove the wingnut, raise the bottom of the section a few inches, then pull the roof section down and then must be lifted and moved to lay on the next section of roof to the right of it. So, you have to stand near to top of the ladder, raise roof sheet up over the bolt, pull down a few inches, pick up the roof sheet and lay it on the next section to the right, remember, you are standing near to top of a fully extended ladder reaching a couple of feet to the right to do all of this. Then climb to the top rung of the ladder to get on the roof to get down inside the bin. The roof ladder is on the section to the left of the extension ladder, if it was fastened to the section next to the removable sheet, you couldn't remove the section. If it's windy, I don't even consider opening it up. I don't want to cut up the rolling ladder, I want a platform to fasten it to at the height I want so I can stand on the platform to remove the roof section to get into the bin. I will then shorten the extension ladder and set it to the bottom steps of the now fastened down rolling ladder. I was think about 4 legs, cross braced, fastened to the bin with a platform on top for the rolling ladder to be fastened to. Clear as mud? If it's not too windy this today, I will climb up the ladder and take a picture of the roof close up. Chris
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
