Posted by LOU from WI. on November 06, 2013 at 09:45:56 from (174.124.56.44):
In Reply to: Concrete block wall posted by Brad Buchanan on November 06, 2013 at 06:56:43:
Hi Brad. I've don a lot of block laying in my time. Taught My son the way I was taught by my pal who had the patience to teach me many years ago. Some things will not be short cutted and if tried will make a sloppy and weak building. I suggest getting instructions from Google . Learn to make footings wide and strong enough to support a wall. Learn to set corners, laying first row as you would lay up any course. String wall. remember to turn the corners the correct way,use level to align wall so it is straight. 1/2 " MORTER JOINTS using small level to make sure the block sets level on the walls. Big 5 ft level to check the block on the outside of the wall so wall doesn't lean out or in. Lots to remember when laying block. Done several buildings and the last one was at my daughters home basement. Victor my son) can do a job of laying block as good as any block layer around. Here is a picture of My Garage and it was the same size as my daughters basement except I added an inside wall for an extra room besides a garage underneath. Do as much reading as .possible ,talk with a contractor who lays em up. Dont be afraid to give it a try. Start the corners right and most likely the rest will come into line. seek advice from one who does it for a living, is my best advice. Learning a new trade from the fellows who does it for a living is a big plus.Remember 3 -8" block equal 4 feet. Regards LOU
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
