Posted by Pops1532 on November 09, 2013 at 03:05:03 from (68.58.114.55):
In Reply to: Concrete block wall posted by Brad Buchanan on November 06, 2013 at 06:56:43:
I agree it's something you can probably learn to do. In my 36 years in construction I've laid just enough block to know I don't ever want to lay anymore!
If you're in a hurry you might want to consider hiring a masonry contractor. A good mason contractor will have at least a 3 man crew. Two block layers and a laborer to tend them. If you said how big the room is I missed it, but a 3 man crew would probably finish the project in the time it would take you to lay up a corner or two 4' high.
Would your time be used more efficiently laying block, or doing something else?
Will you have help? Having someone to mix the mortar and carry block will speed up the process.
Others have posted good advice. The one thing I disagree with is using nuts for permanent spacers or shims. Doing so can create a stress point and could cause the block to crack.
One thing I didn't see mentioned was setting a steel door jamb. It is CRITICAL that the jamb is set plumb and well braced. Don't forget to place a spreader (or 3) to keep the side jambs from bowing inward towards each other when you slug the hollow area between the jamb and the block with mortar.
You didn't say what size block you were going to use. I suggest 8". You could use 6" block but it's harder to get a quality job with the narrow block.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
