Posted by Rich_WI on November 26, 2013 at 12:23:34 from (50.50.82.205):
In Reply to: TIre balancing beeds posted by mss3020 on November 26, 2013 at 07:31:50:
I use them on my truck but I use airsoft beads, not the commercially sold ceramic balancing beads. The airsoft beads are cheaper and easier to get. I bought them as an experiment because there were alot of people on the internet saying balancing beads wouldnt work so I didnt want to invest alot of time/money in the ceramic beads. Turns out all the naysayers havent really done it, just talking about it because the beads do in fact work. http://www.walmart.com/ip/Crosman-Airsoft-Heavy-Ammo-5-000-Ct./9222912 IIRC, its 113 beads per ounce and I use the same weight chart for the ceramic beads. http://www.innovativebalancing.com/chart.htm
I have ran into a couple problems though, measuring out 113 beads is a royal pain in the butt. I tried a few different ways to measure them by volume and none worked well untill I tried a rain gauge and that worked pretty well. I dont remember for sure but I think an ounce (113 beads) came out to 1.25 inches of rain so I just added up the ounces needed in the rain gauge and off I went. Untill I found a good way to measure the beads, it went too slow for me to be happy with the setup.
The other problem I ran into was if the tire was egg shaped, it wouldnt balance for garbage. Even doubling the weight made them still hit and miss for balance. One tire I have is egg shaped and I can feel it going in and out of balance on the interstate but below 60mph, its fine. I decided to leave it till this fall and change it then because its bald anyway so I cant use it for winter. That shouldnt be a problem for most tires but with larger truck tires it is an known issue to have egg tires right from the factory so its worth mentioning.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
