Posted by j hikemper on December 08, 2013 at 09:40:59 from (50.102.7.103):
In Reply to: Cold posted by Waltdavies on December 08, 2013 at 07:02:14:
yesterday went to hale,,22 this am in lueyvil ky area .. lost a newborn calf this early am ,,, Saturday am ,it was ,15 here ,,, sumthin happened to the starter on the daily driver case 500 b ,,had 3 good tractors scattered at different places , miles from home ,one on a auger and another on a wheat drill ,, weak batteries on the diesel s that were left here .. ,and a pissy battery charger ,, best charger was at the other farm , roads were ice , had a decent vac and dc in the back of bunch of stuff , I know I could get them started ,,, BUT ,without a loader could not get to either to get them out, ,What a Predicament .. So,, I fed cows up in nice dry barn ,afterall, I knew I had December calf comin , all was well til THAT One decided to calve and wanted her privacy,,.she had the nice bull calve in the snow ,,in the far end of the 3 acre pasture,, durn it ,, there were 2 hay wagons with hay feeding fodder trash out there she coulda at least went to for some shelter,,,.had I started a tractor, I woulda fed bales in the bale ring and set a fodder bale near the wagons ,,, I still would a put serveral squares in the barn ,,,,, the cows woulda reversed their behavior ,, with majority out in the lot , and expectin mama and her best pal or 2 up in the dry barn ,,, winter is showin its a@$ early this yr..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
