Posted by rankrank1 on December 11, 2013 at 18:38:15 from (166.137.101.169):
In Reply to: Ford 8n or ? posted by Kyle Mills on December 11, 2013 at 08:50:26:
Heck, I do not think I would even buy a tractor if my only use for it was grading a lane every now and then. Heck they make some Reese hitch graders that attach to a pick-up truck hitch that might work good enough for your needs.
That said an 8n will easily handle your box blade duties. While the hydraulics are not live it is really not that big a deal for this application. The hydraulics work anytime the clutch is not depressed so if worst comes to worst simply put it Neutral let the clutch out and you have hydraulics.
Now a 9N or a 2N does not have position control on the 3 point hitch like the 8N does factory. However, you can add the Zane thang to a 9N or a 2N to gain the desired position control for blade work. Cost is reasonable.
Grant there are better tractors out there than the N's, but if the price is right and for your listed uses an N will certainly work.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
