Posted by 4xMF on December 14, 2013 at 13:59:47 from (2.109.156.227):
In Reply to: Sheep herding posted by Harvey2 on December 14, 2013 at 09:39:00:
I keep mine in the same shed as all my machines in the winter if there is no more grass for them in the fields. Feeding them in the shed is much easier than outside in the dark after I get home from work. Besides the law here says they must have a dry place to lie down in the winter months. Best to have them in the field with access to a shed so they can decide where to be depending on the weather. The last two years I have been blessed with enough grass to let them work on all summer and winter so I just let them go without a fence and kept the shed door open. They spend most of the time in the field and only use the shed when it gets too wet/cold/windy in the winter or too hot in the summer. We have typical winter temps between +10 and -30 C (50 and -22 F) often shifting between frost and thaw and summer temps between +10 and +30 C (50 and 86 F).
This spring I lost a lamb to the fox and one year he killed an ewe and her lambs when she was lambing but normally I don't consider them to be a threat. We have very few eagles here but wolves might be something to worry about in the future as they have recently started immigrating.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
