Posted by Goose on December 16, 2013 at 10:19:48 from (70.198.3.36):
Just finished reading a 600+ page book entitled, "Command and Control", by Eric Schlosser.
The book revolves around a Titan II missile blowing up in its silo near Damascus, Arkansas in 1980. Do any of ya'll remember that"? I don't recall hearing about it when it happened.
The book is also an excellent history of the U.S. nuclear weapons industry from the first atomic bombs in WWII to the present. It delves into all of the tensions of the Cold War, and expounds on the inter-service rivalries over control and use of nuclear weapons, also the rivalries between military and civilian control. Plus, whenever there was a change of administration, or even a key personnel change, the whole picture could change. Everyone had their own idea about how and when nuclear weapons should be used.
Truth be told, I was on a nuclear weapons assembly team in the Marine Corps for several years in the early 1960's, and according to this book, the nuclear weapons industry was far less perfection and far more prone to accidents than we working in the industry were led to believe.
After reading the book, my initial reaction was, "Holy s***, I actually survived all of that!"
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
