I have a 3/4 hp pump in basement. It was wired for 240v, but I decided to return it to 120v for 2 reasons.
The main reason is I designed a circuit to detect water on basement floor. It will turn the power off to the pump. This circuit worked best on 120v. 3 months after I wired up water detection circuit, it got tested. Water softner screwed up and leaked a little water on floor.
The second reason is I have an 3500 watt RV genny with a 110v 30 amp out. When I changed over to 120v, I went to Menards and bought a 6 ft 12g extension cord. Used cord to wire pump to my water detection circuit. I can very easily plug a 12 g power cord to pump, run it to Genny. Genny will run pump with no problem. Also put 200 MFD in parallel with pump motor and PF is .99.
Personally, I don't think I use a dimes difference in electricity. Think about it, how many minutes a day does your pump run? Pennies a day.
I have a place in country too. Last year I had a new well put there with a 120v pump. Added water detection there too.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
