Posted by Pops1532 on December 27, 2013 at 11:17:15 from (98.227.133.60):
In Reply to: Ot: sliver question. posted by JayinNY on December 27, 2013 at 08:20:05:
I've been a carpenter for 35+ years. I use my utility knife to remove slivers. Sometimes I even put in a fresh blade to cut/dig the sliver out.
If it's deep you can let it fester and squirt the sliver out. Problem is if it starts to heal you'll have to open it up again to squirt the sliver out.
Metal slivers don't usually work their way out like wood slivers so you have to go in after them.
Worst one I ever had was a metal sliver went through my thumbnail. I dug around it with a new utility knife blade but couldn't get it. I had to take the knife blade and separate my thumbnail from the skin under it, then pulled the sliver out from under my thumbnail with the blade. I apparently made some strange squealing noises while performing that little operation.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Cautionary Tale - by Ian Minshull. In the early 1950s my father bought an Allis Chalmers B and I used it for all the row crop work with the mangolds and potatoes, rolling and the haymaking on our farm. The farm and the Allis were sold and I have spent a lifetime working on farms throughout the country. I promised myself that one day I would own an Allis. That time event
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.