Posted by Buzzman72 on December 30, 2013 at 16:26:00 from (74.133.160.172):
In Reply to: Re: Firing Order posted by JMOR on December 30, 2013 at 14:16:39:
ON a 4-stroke cycle engine, it takes TWO revolutions of the crankshaft to complete a combustion cycle. So a cylinder is firing every 180 degrees of crankshaft rotation. Let's look at what happens on an engine with a 1-3-4-2 firing order.
When #1 cylinder moves from TDC to BDC on the intake stroke, the intake valve is open. As the piston passed BDC and moves into the compression stroke, the #1 intake valve closes. At the same time, #3 cylinder has the intake valve opening on its intake stroke. When #1 fires and begins its travel to BDC on the power stroke, #3 is moving up to TDC on compression stroke...and #4 intake valve is opening on intake stroke. As #1 exhaust valve opens and #1 cylinder moves from BDC to TDC on the exhaust stroke, #3 is on its way down to BDC on the power stroke...while #4 is on its way to TDC on the compression stroke...and #2 is on its way to BDC on the intake stroke.
So tell me...at what point do two adjacent cylinders BOTH have their intake valves open?
Not trying to be a smarta**..just trying to understand what you're saying, as it relates to a 4-stroke engine. [On a 2-stroke engine, the intake valves on #1 and #4 would be open at the same time, and the intake valves on #3 and #2 would be open at the same time. But 2-stroke 4-cylinders are extremely uncommon here in the US...so the assumption is that you were talking about a much more common 4-stroke engine.]
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
