Posted by NCWayne on December 30, 2013 at 19:33:03 from (173.188.169.54):
In Reply to: dumpster diving? posted by Larry@stinescorner on December 30, 2013 at 14:10:26:
Used to do a lot of work for a HUGE contractor local to us. When they"d get a CONEX back from a job it was nearly always full of tools and supplies left in when the job was complete. Instead of cleaning them out, cataloging what was in the container, and reusing it on the next job, they would throw it all away. The thinking was that it cost less to throw it away than to reuse. Basically, since everything was already paid for from the job it was used on, and the tools needed for the next job would be paid for in it"s budget, why pay someone to sort everything out when all they had to do was pick it up and dump it in the nearest bin. Needless to say Dad and I got a lot of good stuff from them until the parent company, overseas, went under and took them with it.
By far though, the worst place I"ve seen for waste is the RR. When they take a piece of track maintenance equipment in for a rebuild, EVERYTHING gets taken off and scrapped. By everything I mean even hydraulic fittings get thrown in the scrap, regardless of whether it"s a dollar, 1/4 inch fittings or 100 dollar, 4 inch fitting. Too pretty much everything else including valving, electronic components, etc, etc all get thrown in the apprppriate scrap bin. Makes me sick every time I look into a bin and see all of that good stuff lying there...........
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
