Posted by davpal on January 04, 2014 at 00:14:52 from (216.93.108.62):
In Reply to: Dodge Heater posted by super99 on January 03, 2014 at 17:44:06:
It's not that bad to pull the dash on a Dodge. The fords are a pita. I did mine in a few hours. I cheated a bit on the heater core change. Dodge wants you to pull the air conditioner evaporator on the firewall in the engine compartment to get the heater core out but I figured out how to change it quicker. The heater core lines go through the firewall. Cut them off with a hacksaw and lift the old heater core out. Now you can either cut the new heater core the same and use hose clamps to put the ends back through the firewall or do what I did. Auto zone sells an aluminum heater core that you can uncrimp the ends and they actually pull out of the core just like a quick connector. Pull them out, put the core in and put the ends back in the core. Recrimp the ends back on and check for leaks and put the dash back on. If you have to you can also change the blend door at that point. It took me a few hours to pull the dash, steering column and everything out of the way to get it ready to pull the core. Mine was leaking and not heating very well.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
