Posted by Bob on January 04, 2014 at 14:15:38 from (64.255.159.192):
In Reply to: O2 sensor posted by Chris Jones on January 04, 2014 at 13:29:36:
First of all, if it is CCCCOLD where you are, I would clear the code and see if it returns
On your truck, bank 2 is RH/passenger"s side.
The front sensors provide feedback for the fuel control system.
The "2" sensors (Bank 1 sensor 2 and Bank 2 sensor 2), behind the "cats" report cat efficiency to the emissions warning system and DON"T/CAN"T control the fuel, so if there is NO code for the front sensor, it is strictly an EMISSIONS problem, NOT an engine or fuel system problem
Your PO161 code specifically points to the HEATER circuit that warms the sensor so the system can go closed loop.
I would ASSUME the computer keeps tack of the time, after startup, how long it takes the sensor to "come on line" (heat up and produce a signal), and if that takes too long or does not occur at all the code will be set.
Condensed moisture in the exhaust system, or snow and ice caked under the vehicle can cause this,m as well as a failed sensor or a problem in the heater supply circuit.
So, it"s NOT an emergency-engine"s-gonna-die situation, and I would clear it and not get too excited about it "til warmer weather and IF it re-occurs.
If you are NOT subject to emissions testing in your state, considering the vehicle is 13 years old and you MAY not want to start throwing a lot of $$$ at it, you can have someone with a "tuner" program (such as HP Tuners) simply tell the "puter to IGNORE the rear O2 sensors.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
