Posted by Case Nutty 1660 on January 06, 2014 at 03:45:01 from (75.127.24.27):
In Reply to: PTO chipper posted by Whichester1 on January 06, 2014 at 00:52:41:
I really like my Bearcat 5" chipper/shredder they are now Echo/Bearcat only thing I would do different if I could go back I would buy a blower for it to load the chips rather than just dropping them on the ground as if you are chipping a lot of material you do have to move the chips away but that is no real issue either for the amount I chip I feel it would be handy though, I have had it 10 years and other than sharpening blades I have done nothing to it not even adjust the belts yet a very tuff well built unit, with 5" wood it will make a 20 hp tractor work, the 35hp 430dsl its own runs it fine, I do not use the shredder much but it does work well, buy the shredder tamper tool if it does not come with it if you chose to go this way good luck cnt
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
