I remodel bathrooms so caulk removal from around the rim of the tub is something I've done a Lot of. Get a very sharp 3/4 or 1" wood chisel. Lay it flat on the tub and Carefully work your way around it at right angles to the seam. It will cut the caulk off the enamel. The sharper the chisel the better. You will leave a few black marks on the enamel but use Zud or Bar Keepers Friend scouring powder and a green 3M scrubber pad and you can easily remove them and any residual caulk. Careful with the pad as you can easily over do it and mar the finish on the enamel. The same technique works for plastic tubs but you have to be supremely careful with the chisel and don't use the scrubber pad. Use a soft cloth with the scouring powder. (I hate plastic tubs and surrounds anyway) I don't mess with sharpening chisels. I just buy new Woods Bros set of 3 for $14 at Home Despot and bill them to the job. Afterwards I give them to the homeowner.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
