To specifically answer your question, a typical electric heating baseboard has a capillary tube running it"s full length, as part of a temp limit switch that is supposed to cut the power to the entire heater if ANY section of it gets extra hot due to lack of air circulation in that area.
That being said, in my limited experience, I can immediately think of 3 incidents I personally know of in which things didn"t work as designed... in one situation, folks returned home and found their drapes that were hanging over an electric baseboard smoldering, in another case a neighbor had her son and friends home for the weekend waterfowl hunting and they woke up to a screaming smoke detector... a canvas duffel had got shoved against an electric baseboard and began smoldering during the night.
The third incident was a plastic laundry basket my folks had in the bathroom of their apartment... It was against a short electric baseboard and the plastic "webbing" got melted all to heck by the baseboard.
I still have that basket (as a good bad example), and will try to remember to take a picture of it tomorrow and post it.
After those incidents, I really don"t trust electric baseboards.
The house we live in originally had under-slab heat beneath the lower level which failed before we bought it and electric baseboards were installed.
I have removed them and put hydronic baseboards in the main area of the lower level, and electric cove heaters in two bedrooms and two baths. They mount high on the wall and eliminate any chance of furniture, drapes, rugs, clothing, or fabric items coming into contact with them and melting or igniting if the safety thermostats fail.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
