Posted by Neil T on January 12, 2014 at 19:17:07 from (99.224.66.10):
I do not know anything about tractors and not nothing about hauling logs with one. I am looking for advice.
I would like to buy a tractor to pull out some cedar logs. I am looking at a MF 35 with a front end bucket or loader and a 3 point hitch. Alternatively I was thinking of an 8N but apparently they are prone to flipping (I am not sure about this part). The cedar trees are not that big - maybe 20" from the bottom to the top where it is 4 to 5 inches. I saw another discussion on the same issue where the person was dragging logs out using his 3 point hitch with a draw bar attached? Does this make sense. There is an issue with tractors catching the log on something and then flipping backwards. The suggestion was to get right over the front end of the log and then lift it up high with the 3 point hitch before pulling it out. They also suggested cutting the limbs off and the top off before moving it so there was less weight and less likelihood of catching on something.
The tractor I was looking at is a MF 35. It has a front bucket loader. I thought I could hook the front bucket on the log, lift it up and drag it backwards out to the road. Then if it catches on something, The front will be held down and will not flip over. The worst that can happen is I hit something on the way out backing up. If the chain snaps it is short and unlikely to do any damage or whip around.
Alternatively, if I can run a cable from the front bucket of the tractor through a pulley attached to a tree at the road and then to the tree I want to haul out. Then I can back down the road, which will again eliminate flipping. However, I could get the tree hung up and snap the pulley or the cable. The pulley is good for a ton and the cables are usually much stronger. If the cable snaps it can whip around and really hurt someone. But if the cable is stronger than the pulley, the pulley will break first and there should not be a problem. Well that"s what I was thinking.
Does anyone have any idea what is the best way to haul logs or any comments or suggestions on the above?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
