Posted by Janicholson on January 16, 2014 at 17:19:46 from (74.60.94.18):
In Reply to: Ford 9N posted by Harold C on January 16, 2014 at 17:02:27:
an ignition resistor is used to lower the voltage supplied to the coil while running. This allows a coil with a lower voltage design to be used for running, while a separate wire is used to supply full voltage during cranking with the starter motor. The cranking motor draws enough amps to lower the battery voltage to 4.5 or so. the bypass thus allows hot spark for starting at that lowered bat voltage. If the wire is bad, a 1.5 ohm 40 watt power resistor could be used instead with plain 12ga copper wire to the switch. Ford used a resistor wire in many vehicles including cars into the 70s. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
