Posted by T in NE on January 16, 2014 at 19:48:36 from (75.235.150.150):
In Reply to: Gas Tractor and GPS? posted by FC Andy on January 13, 2014 at 14:05:49:
If it will let you, you will want to set it so that the light bar shows farther ahead of the tractor, say 8-10 seconds. I set it for at least 6 seconds out. It's tough to remember to watch the light bar and not the screen when turning around. The screens will always be a few seconds behind, but the light bar is always where you set it. If it shows 1 second ahead (factory default on a Trimble), it will be real tough to keep up, as it doesn't take much to oversteer the bar. Kinda like picking a rock in the middle of the field, vs picking a tree at the far end, for a guide.
We upgraded my unit from the Trimble 500 to the 1000 last year. It's a touchscreen and a lot smarter. But still lags way behind the JD system I've run in following curves (it still can't).
I don't think the Trimble systems are easily portable, as it has a box with accelerometers in it that has to be bolted down to the tractor. Depending on how hard those steer, if you upgrade to autosteer some day, you may need the hydraulic set-up instead of the motor on the steering wheel.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
