Posted by Hal/ Eastern WA on January 22, 2014 at 13:38:09 from (97.114.74.200):
In Reply to: Hay Hooks posted by 37Chief on January 21, 2014 at 13:14:06:
Growing up, I moved a lot of hay. I started at the age of about 8 or 9 and was not a big kid at all. We had wire tied bales in the early years, and sometimes the bales were heavier than I was. It was a real chore to lift a heavy bale up on the trailer deck where my brother would stack, but somehow we got it done. Over the years we had a number of hay hooks. I tried the D handles, but preferred the T handles. We wore gloves whenever we were moving hay, and I don"t see how someone could move very much without gloves--there would be LOTS of blisters.
One time somehow or another, a hay hook was found stuck in one of the tractor"s back tires and calcium was spraying all over. No more haying that day, but the next day we got going again after the tire was repaired. I think my younger brother forgot what he was doing and just dropped the hook. My Dad was not pleased!
Later we had twine tied bales, which were not nearly as tight as the wire tied ones had been. I moved some twine bales by the ties, but occasionally had trouble with the tie coming off. Usually we used hooks on the twine bales.
My favorite hooks were homeade by someone and were all metal. The hook part would not turn like some that we had with wooden handles.
I hadn"t thought about hay hooks for years! I probably still have some among the old equipment I took out of the barn before we sold the buildings.
Do I miss moving small bales by hand? Not on your life! But hooks and the hay conveyor made it a lot easier than not having them. Good luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.