Posted by Bret4207 on February 01, 2014 at 05:17:19 from (64.19.90.196):
In Reply to: Frozen water line posted by TGIN on January 31, 2014 at 10:13:36:
I just had a post a few weeks back about unthawing plastic lines. What I did is get so fairly stiff tubing that would fit in my line and go through the unions, 1/2" ID-5/8" OD in my case for a 1" black plastic line. I also got one of those drill powered pumps and a couple of 1/2" garden hose fittings that fit the pump outlet. Feed the tube into the pipe and start pumping warm water into the pipe. I used a big old stock pot on my Coleman stove and let the water run back into the stock pot as it came back out the pipe. Keep feeding the tube into the pipe. If you have unions in the pipe, it helps to put a smaller fitting on the end of the hose to get centered in the union. I used a 1/2" Shark Bite union that I happened to have, it pressed in fine and allowed the tube to center in the union. I've used this method 3 times and unthawed over 40 feet of frozen line in 1/2 hour-45 minutes. I stated out with 25 feet of tube, but now use 50 feet as the frost sinks deeper. Last time the pump switch broke and the line was frozen for a week. Had to wait for a day when the wind would allow me to work. As long as there are no elbows, this should work for you.
Those little drill pumps need a good shot of WD40 or oil every 5 minutes or so. I tried using a suction hose leading into the pot but ended up just sticking the pump in the water. Tedious, but it works.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
