Posted by Edd in KY on February 06, 2014 at 09:47:57 from (98.23.50.118):
In Reply to: Back surgery posted by MTC on February 05, 2014 at 17:21:45:
I have been thinking about my reply to you. I did not ask enough questions with my first surgery, and the Doctor did noit put enough restrictions on me. I was much more forceful with the second doctor, met with him 4 times, pre-surgery and 3 times since. Glad i had it, but it is an ordeal.
There is a small chance you could break the rods and screws, and a chance for "adjacent Facet deterioration". goggle it. That is what my doctor suggested. I did a lot of research before the surgery, but I really had no choice. I could hardly get out of bed, was in constant pain, and was losing the feeling/use of my left leg. So I had to do it. I was 69 at time of 2nd surgery.
Get a good experienced Doctor, do your homework, and then play by the rules after surgery.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
