Posted by Crazy Horse on February 16, 2014 at 13:44:09 from (75.158.38.154):
Question here about the relationship between an ammeter gauge front dial and the terminals on the back side of the gauge. This question relates to gauges with the needle pivot on the bottom part of the needle (most common type for old gauges)and the pointer end of the needle facing up.
Do most gauges have the wiring terminals correspond directly to the + or - side that shows on the gauge dial? So looking at the gauge from the front, the left would be the - or discharge on the gauge face, so would the terminal immediately behind that on the back of the gauge be the negative terminal? And the same on the right side but positive?
Seems I remember some gauges being opposite from the front face + and - to the backside terminals. And when wiring up a tractor, you can never be sure except to test what you have hooked up and see what the needle does when the tractor is running and charging?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.