Posted by John T on February 17, 2014 at 12:44:59 from (107.31.64.109):
In Reply to: 6v to 12v posted by Dieselcowboy on February 17, 2014 at 09:46:43:
I have successfully used 6 volt generators to charge a 12 volt battery by ONLY changing the Voltage Regulator to a 12 volt. NOTE Billy Bob, I'm NOT saying it sets the world on fire or charges at any super high rate, I'm ONLY saying it can work, here's the theory and reason why:
Basically a genny don't necessarily know its output, that's increased by 1) Turning it faster or 2) Pumping more current through its field coils which increases their magnetic field strength. The VR is what determines and regulates how much current to pass through the fields so if a 12 volt VR is installed it can allow more current through the field coils so she can charge at 12 volts.
NOW BEFORE ANYONE HAS A CALF HERES THE DANGER:
The 12 volt VR MAY PUMP MORE CURRENT THROUGH THE FIELDS THEN THEY WERE DESIGNED TO HANDLE AND THAY COULD OVERHEAT. A genny shop can change out the field coils to those rated for the amount of current the VR may allow.
So, YES it can work, YES Ive done it and never had any problems, HOWEVER as an Electrical Engineer Im NOT recommending you try this at home lol do it at your own risk, the more correct engineering way would be to have it converted although, as I say, Ive done it no problems!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
