Posted by John T on February 18, 2014 at 05:11:35 from (108.106.209.146):
In Reply to: Outlet box grounding posted by Bkpigs on February 18, 2014 at 04:33:21:
When I was an electrical design engineer I always specified BOTH (Metal Box & Receptacles Green Grounding screw) were to be connected to a Green/Bare Equipment GroundING Conductor. Our electricians used the little braded wire grounding pigtails with the green screw to ground the metal box and sometimes used greenies with the green wire nut having the hole out the top for splicing all the ground wires together with the extra long wire out the top to attach to the Green Ground screw on the receptacle itself (or vice versa to the receptacle). NOTE there are other ways to accomplish the same, but regardless I would somehow attach BOTH the metal box and the Receptcles own Green Grounding screw to GroundING Conductors even if only one were used a contact between the receptacles mounting strap and the metal box is present. But that's just me and my years ago NEC training as I best recall it IE GROUND BOTH
Sure Billy Bob, if EITHER the metal box orrrrrrrr the Receptacles green grounding screw are grounded, those two get connected together when the receptacles metal mounting strap screws into the box, and yes Bubba that can work to bond both to the Equipment GroundING Conductor BUT FEEL FREE TO DO AS YOU PLEASE.
Also consult with local authority or the Utility as to what they require (NONE of us here)
NOTE This, like all other posts here (Electrical and Legal questions always draw plenty of opinions) IS ONLY MY OPINION with NO warranty, it may be right and it may be wrong, I'm NOT saying if it is or it isn't, I'm ONLY saying that's how I did it when and where I was a design engineer. Yall wire anyway you please.
John T Too long retired Electrical Engineer and rusty as an old nail on the latest codes, so some may agree with this and others may not, lets see lol
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
