We build a new machine shop at work in 2006. Put in T8 lights. The shop is heated and cooled, so conditions are ideal. We had the lights on 5 days a week for 6 years before we had ANY failures. Since 2012 we have been replacing maybe two ballasts and two sets of bulbs a year. Probably 40 ballasts in that shop. In December my shop at home needed new lights. I had OLD T12 that wouldn't come on if it was under 30 degrees. The ceiling in this shop is low, only about 7 1/2 ft. I installed Lithonia L232-MW lights. Got them through work at wholesale for $44/each. I too was concerned about cold starting since they aren't rated for low temp. I have had ZERO issue and we have had a super cold winter in PA this year. The shop is unheated, and I went out one morning when it was 5 degrees and flipped on the lights. It took maybe 2 seconds, and they came on. They ALL came on, and they were all bring. Not like the old T12 where the bulb would just kind of glow a little. My buddy installed T8 in his 14 ft high tractor shop, and he loves them. He went with 4 bulb per fixture with chrome reflectors. Really lights the place up. Just make sure you stick with brand name fixtures, there is probably a lot of junk coming from China...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
