I pulled part of one that cracked in half at 6 pm one night last October, Told the dental receptionist it was buggin me real bad before it broke, said they hadn"t got time to see me before next appointment.
I had told them once before. If I phone and say it"s buggin me it"s pretty bad I want to see someone, or I"ll smack the next guy that annoys me in the shop or pull it my self. I have high pain thresh hold and they know that. Had 2 top wisdoms pulled there, Dentist said he"d never had any guys in his chair pullin back as he pulls down n forward. said most peoples heads follow him pulling Well I had no choice but to pull this half my self, couldn"t eat talk or shut my mouth right.
When they phoned to confirm next app. she asked how that tooth was. Just casually said "remember what I told you once", she said yes. then she said "I hope you never smacked the guy". said nope "half that tooth"s in the draw by my bed". it kinda went very quiet, she new I wasn"t bluffing on at least one part of what I told her one day. I got to the dentists he took one look as the receptionist had told him. All he said was in 30 years. I have had guys threaten to pull their own teeth, but never had a guy even close to following through.
All I will say is i tried 3 different small pliers in my model makers plier kit, before I found something that worked and 2 Tylenol, Don"t work 1/4 as good as what the dentist gives you.
Make your own choice is all i will say! Regards Robert
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
