Posted by Janicholson on March 01, 2014 at 06:09:07 from (74.60.94.18):
In Reply to: Re: frost line? posted by George Marsh on March 01, 2014 at 05:23:02:
THe selection of earth heat depends on that question. The answer is arrived at through consideration of soil type, and climate zone/frost depth. 15 feet is not uncommon with a horizontal grid of collection tubing in cold locations. Other options include one way pumped well source (pretty common where the outflow can get percolation back to the aquifer). another is two wells separated by several feet or in some cases yards that draw from one and inject into the other, a recommended practice where wasting ground water would be a very bad idea. and one other where water level in a well is 20' or so above the bottom of the casing, is to usw a down the well heat exchanger with pumped fluid in the exchanger. I hope this helps, earth temps vary from about 50 degrees at 3 meters, to 60 degrees at 3 meters in southern areas of the US. There are charts, my numbers are approximate and local measurements are easy to make in a well casing. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather’s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
