Posted by George Marsh on March 07, 2014 at 09:54:31 from (64.12.116.16):
In Reply to: Re: Solar heating? posted by VaTom on March 07, 2014 at 06:40:11:
Tom, I don't figure I have a problem with the air in my houses. All my places are total electric, baseboard heat. Compared to porpane, natural and heat pumps, my electrical bill is hundreds below theirs. During the record cold month, I paid $316 for heating and all the electricity I used for hot water heater, stove, lighting, refrigerator, electricity in work shop. During the months when I don't air condition and heat, spring and fall, my electric bill is $80-90. So bottom line I may have paid $225 for heating during a record cold month.
Seriously, there is no way a heat pump would ever pay for itself, even if it saved me all of the $225. According to the internet, the AVERAGE life of a heat pump used all the time is 14 years. It said tht very few lasted 21 years. If I saved $500 a year on a heat pump, 15 years = $7500, the cost of an air to air heat pump.
Now I know this will cause a stir, I did some research in the internet. It says most heat pumps are lucky to save $250 a year, both heating and cooling, $.085 per kw-hr. It also said heat pumps are costly to maintain. Now if you talk to someone who has one, or sells them and you get a totally different opinion. Some will tell you their heat pump came over on the Mayflower and it saves them $1000.
I like to use the tried and proven, caulking and insulation. My homes have a minimum of R20 in walls, R50 attic. Thermal pain windows, brick siding, insulated doors. I spend money on making a well insulated home over alternative heat sources.
I have rental houses, 5 have basements. The humidity in my area requires either I use dehumidifiers or centeral air to control moisture. Venting a basement in the summer is like pouring gas on a fire. You want to keep the moisture out, not vent.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
