Our summer range shelters were A frame type, about 12' x 16', with 2"x4" mesh floors. Manure fell right through, and we just pulled them off with a tractor to expose the manure to clean up. Nests were built in the end with an access panel from the outside. The main laying house where they were kept through the winter had a solid floor with "built-up" litter. About 8-12" thick bedding of wood shavings or sawdust. We only skimmed off the top of the litter with a 5 tine fork about once per week. The depth of the litter and bacterial action took care of the rest. The litter was never removed, just skim off the top and replenish it occasionally. We had separate roosts that had platforms under them that also had to be cleaned out every week. Dad used this method from 1928 until 1962, and had 2,000 layers. All of the feed was carried by hand, and the manure was removed the same way. My hands are very well acquainted with a 5 tine manure fork and a #14 grain scoop.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.