Posted by showcrop on March 21, 2014 at 10:00:09 from (75.67.231.80):
In Reply to: Drainage posted by Why Worry on March 21, 2014 at 08:19:08:
As everyone else is telling you, do it the way the rest of the world does. Depending on where you live, you drive over a 2-5 every mile. Stop and look. I would get a plastic culvert myself and use a plastic funnel at each end. If you want to get fancy you can get precast headers. Dig a catchment pool on the high side and line it with erosion stone, to keep the culvert from filling in with silt. I had a problem with a wet area on one of my fields due to an old class six town road next to it. I knew where the town had parked some old culverts on some town land a few years earlier, so I went there and got the contractor who was working on a project there to load them on my trailer. I then dropped them off at the class six road, dug a ditch across the road and laid them in. A senior citizen abutter got upset with me, but I convinced her that there was not one ounce more water coming onto her property.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
