Hi Something you have to remember with tractors is the clock resets at 10.000 hrs on most. you have to start looking a ware on linkages clutch and brake pedals to see how warn dimples are on them and other general stuff like tires being original or half worn replacements.
I have personally seen some that the only way a guy new it was 16.000 hrs not 6000, was the guy was honest and told me. The tractors had high standards of maintenance/service and 1 or 2 drivers assigned to them from new with the farm they were on.
Just had to tell a guy thats had a 1830 Deere from new it's mechanically worn out at 16000 hrs, only thing appearance wise wrong was 1 odd tire and some rot in the rear fenders on an early 70's. tractor. I know another guy got a 5000 hr 4010 clock works but when you look at gear shift linkage and other ware its closer to 15.000 hrs and worn out to.
Older low hour tractors can be a pain just the same as low mile vehicles. A guy babied it the next guy puts hard work on it then everything that fell off the rest of them under warranty falls off when you own it, and have to pay to fix it. There is no real easy answer to it. I would rather have higher hours well maintained/ all updates/ warranty work done. than low hours never greased or serviced, updated personally. Some of this stuff out there is 1 careful lady owner and 99 idiot drivers from what I see round L.O.l. That can be on 2 year old expensive stuff, which gets real worrying, when dealers clean it up and fix the damage. Regards Robert
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
