WGWKy2's advise sounds very good. Especially as you already know the line is shallow and you have posted so on the internet.
In my area I'm required to get utility lines marked before digging near them, and then to only hand dig near the marks. It's only the utilities problem if the lines are not where they were marked. That could be difficult to prove after you have tilled over the marks and most of the field surrounding the power line.
I would not trust your neighbor's advise that you hitting a marked powerline won't be your problem, unless he's willing (very doubtful) to pay all your legal expenses, emergency repair expenses, and medical expenses. He and many other people probably won't be very happy with you after their power goes out for half a day or more either. How many homes, farms, and businesses are supplied by the power line?
How high is the voltage in the power line and how dangerous is it? If you do snag a high voltage electric line, to avoid electrocution, for sure don't touch both the ground and the tractor or implement at the same time. Other people on this forum may know for sure, it might be safest to just stay in the tractor seat until the power company confirms the power is fully disconnected.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.