Wow! I see what you mean about the flames. Yikes.... My humble opinion as a mechanic with over 40 years of experience is that it would probably run for a while without problems. As previously stated, the purpose of the boot is to keep the dust and dirt away from the moving section of the piston and seal. It would take a while for enough contamination to get into it to cause problems. The problems it might eventually cause would most likely be a stuck piston that could cause the brake to drag.
To explode a couple of incorrect statements: 1) The boot would very likely NOT be an easy part to get by itself. Nor would a repair/rebuild kit. These days, it is preferred to replace rather than repair. I don't agree, and find this practice wasteful, but that is what the world is coming to.
2) NO, she is NOT going to run over somebody because the brakes don't work. Simply put, the worst case scenario would be for the caliper to get stuck and potentially lock up that one brake on that one wheel. No need for all the drama on that one.
3) Have you checked into the price of a replacement? Many replacement calipers are quite reasonable these days. Especially if this one does NOT have the parking brake as part of the caliper. The trend these days is to have a separate small drum brake built into the inside of the brake disk. That simplifies the rear caliper and makes them a LOT LESS expensive.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
