Posted by caterpillar guy on April 16, 2014 at 04:26:33 from (24.231.176.149):
In Reply to: Grain Bin pad posted by LeonardWD45 on April 15, 2014 at 08:09:28:
Go with the air floor. If you get them from golden grain they are about half the price of the rest of the market. I am going to get one before this fall for a 27 foot bin. Also going to put in a 10 inch load out auger. If I go to a 10-12 inch transport auger. The 6 and 8 inch stuff will never keep up with it. If you have a rat wall about 18 inches deep with 4-6 inch floor will be good. The pour will also be much easier with an air floor. The 2 27 foot ones we have are still good floors with those figures. One built in about 71 the other built in 82 so been there a while. You will want figure for the hold downs or drill afterwards your choice.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
