Thats the worst way to deal with sod. Soil that has been covered in sod for years has exponentially more soil life than most cropped ground, not to mention the organic matter that exists on top. Why would you want to tear that up and roll it under where it will take months to decompose? Burn it, and no-till your corn in. Try it, you'll be pleased with the results. Always moldboarded sod, for the same reasons RRLund said, until one year the neighbor convinced us to no-till our corn into old alfalfa stands. It made believers out of us. The burnt sod on the soil surface acts as an insulator, protecting the ground from the hot sun, thus making it more resistant to dry weather. It was a drought year and our corn looked and did better than most of the neighbors who all do conventional tillage. Also, I've been told theres less compaction in the sod ground due to all the long alfalfa roots breaking up the pan. Not to mention, you use a heck of a lot less $4 diesel with just a pass going through to spray and one more to plant. The following year, we no-till beans in, but, we also have been known to chisel and plant oats. The ground chisels beautifully after a season of corn. Now, our mold boards are rarely used, collecting bird sh87 in the shed. Just my thoughts on the issue....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.