Posted by Billy NY on April 17, 2014 at 10:15:38 from (66.67.105.23):
In Reply to: Re: no till vs tillage posted by jennifer408 on April 17, 2014 at 09:43:12:
Its shown in this old plow diagram, now as far as the meaning, or where the word was derived from, I would think its a little self explanatory by what it does, I've also heard of a motor grader blade, being called a moldboard, and I assume that to be the half round part of the blade that is not the replaceable cutting edge, performs the same,like the plow, but usually with loose soil. On the plow the cutting edge would be the share. The diagram below shows an old style plow, the moldboard is one piece, unlike the more modern plows, there is a replaceable wear part called a shin, which would be the front section of this one piece, making 2 separate pieces, that part of the moldboard being the leading edge, will wear faster than the rest of the moldboard, so plow manufacturers at some point must have decided to eliminate the one piece moldboard, speculation on my part, but I am sure there is a lot of interesting history behind that word, "moldboard"
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
