Posted by Freewheelin' on April 17, 2014 at 17:59:55 from (108.68.83.217):
Tuned up a 901 Ford with new plugs, points, rotor, condenser, cap, & wires. Runs OK except for a momentary hesitation when I open the throttle. Owner tells me it wasn"t present before. The carb is a TSX 662 Marvel Schebler. I"m not familiar with this particular carb but would expect this to be normal since there is no accelerator pump. Is it? The power needle initial setting is 1- 1 1/4 turns but the tractor couldn"t pull itself up a small grade set at 1 1/4 and doesn"t reach max power until it"s about 2 turns. Again is this normal? Finally I can"t get a rich idle mixture by turning the idle screw in. My dwell meter fluctuates wildly so I"m not sure what RPM it"s idling at. Is the 400-450 RPM spec critical? I"d appreciate any help from you Ford experts.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.