Posted by John in La on April 18, 2014 at 07:11:55 from (96.33.136.54):
In Reply to: Is this safe?? posted by John in La on April 18, 2014 at 04:24:55:
Just to clarify........ The hitch is bolted down with 6 bolts (3 on each side)
You can see the rear bolt with the plate. The long end of the plate with the hole in it faces the rear of the truck. Notice he only had one length bolt so he used what looks like a piece of pipe as a spacer on the top.
The center bolt is threw the cross member. I did not think to look at how the cross member is attached to the frame rail.
The front bolt looks the same as this rear bolt and plate setup but the long end of the plate faces the front of the truck.
So basically 2 of the bolts are threw a cross member and 4 of the bolts are only threw a 2x6 piece of pine.
Think about it for a minute........... The weak link is not the bolts and plate. It is the wood screws that holds the 2x6 to the cross members. So basically this hitch is held on with 2 grade 2 bolts. The only thing the other 4 bolts; the 4 plates; and the length of the tubing does is stops flipping of the hitch forward or rearward. In sudden stop that hitch is going to shear those 2 bolts and pull the whole 2x6 off the bed of the truck because only wood screws hold it down.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
