Posted by bryan iniowa on May 05, 2014 at 16:22:51 from (70.198.24.245):
In Reply to: Re: OT Basement posted by Pops1532 on May 05, 2014 at 14:42:17:
Thanks . Two bedrooms, bathroom, open area for bar etc . One room for my reloading bench and gun safes. They manhandled a power trowel down there. Did great job on finish. Used " Form a Drain" for footings. Its tied into sump pit. After solid week of rain I had about an inch of water in pit. The sump pit cover sticks up above floor a little. Wasn't required to have one but thought foolish not to. Also did 20 x 8 inch footing . 16 x 8 was code. Pretty happy to be at this point. Roughly four years working on it. Got burned out few times and took few breaks from it. Thanks for all the great advice and encouragement from everyone one here. There will be a party and your all invited!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
