Posted by John A. on May 08, 2014 at 16:55:07 from (64.128.16.238):
In Reply to: Re: OT shoulder posted by mustangkev on May 07, 2014 at 13:45:05:
mustangkev, I will Never hand dig a posthole, or use a Stud Bar to break out Huge rocks in the bottom of said holes. Run an Ax. Run a Chain Saw for that is a tough gig,,, afterward! I can throw a Base Ball, Some! but my shoulder feels real weird, Underhand Fast Pitch style is no problem with my only son, Batting practice is not high priority, Not a motorcycle rider so that wasn't a concern either! I CAN Step up a horseback and still rope a Steer in decent enough time!!!!!!!!!!!!!!!!!!!!! I blew out both shoulders in 15 minutes of each other.....on the same Post hole on My Cattle Crowding alley, Many yrs ago. Hope this answers your questions, Holler at me if you like! Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
