Posted by John T on May 11, 2014 at 06:12:18 from (216.249.72.121):
I've been shopping for a new electric brake controller for use in the RV used primarily when towing my single axle combination (golf cart up front sideways, towed vehicle in rear) Tow Dolly equipped with Dexter Electric Brakes.
The choices are TIME BASED control which I believe??? doesn't use any internal pendulum or know how hard you're braking (doesn't sense deceleration) I think??? they just apply more power to the trailer as time passes.
The other choice is the inertia and pendulum PROPORTIONAL BASED units which sense deceleration so the harder you're braking (greater deceleration) the more power it applies to the trailer brakes.
Okay, I drive like an old man in the RV especially when towing, so most of my stops are veryyyyyyyy slowwwwwwwwwww and deliberate with "usually" no hard sudden braking. It's my thinking with a time based controller and my longggggggg easy brake times, over time the trailer brakes are gonna be over used. HOWEVER if using an inertia pendulum type with my long gradual slow downs, the brakes may never even go on much if any on the trailer. I also think in an emergency sudden hard panic stop when you really need the trailer brakes, the pendulum inertia controller is going to apply more trailer brakes quicker then a time based unit.
SOOOOOOOO my conclusion is I should use an inertia pendulum PROPORTIONAL type versus a cheaper TIME BASED controller.
Thoughts, corrections???
PS Yes, Billy Bob I have a 22 ft (18 + 4) tilt bed car hauler type trailer with electric brakes on both axles I could use, and I sometimes tow the car alone 4 down in which case I use a Brake Buddy auxiliary braking system, but this question concerns the electric brake controller choices listed above. Yes I believe Tekonsha is a good unit, but there are others out there.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.