Posted by fastline on May 16, 2014 at 13:07:35 from (99.13.20.112):
I have some issues with the snap on duals for my Case 1170. Needs tires, rims need work, etc, and I just don't have the time.
I need to lightly turn some thatch in 40 acres with an 18ft offset disk. My plan is to set stops with the lift cylinders to do a light cut. I have looked at some data that indicates around 100lbft per inch depth per foot width so that might indicate 1900lbft per inch of cut? Seems like a lot to me.
Regardless, I am sure some experienced farmers would have a good idea on this? Again, I am NOT planning to drop the disk down and let it eat, just need to roll the thatch a bit so I can get a cover crop seeded in.
I would think at some speed, the tractor would do it but I figure traction could become an issue. The tractor does have weights on the rears and I think weighs around 15,000 with the FIL and weights.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - On the Road with Dave Gohl: Auction Musings - by Dave Gohl. I was thinking the other day about all the auctions I've been to in the last few years. There've been many. Some have been very good, some have been well, disappointing to say the least. But no matter how good or bad auctions may be, we always seem to stay until the item we've come for or are interested in is on the block. I've been to some auctions near and far. I think the furthest has been the Two Cylinder 7 in the Amana Colonies last year. Lots of stuff, lots of people. I've also atten
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
