You'll need to get "some" access to it, probably remove the fuel tank. Using a dull chisel, just tap it in until it turns sideways , then try to grab it with channel locks or vice grips and pull it out. If it falls inside and you can't get it out, just leave it.
Be very careful though, when tapping it in, be sure whatever tool you use doesn't cut through the rim of the plug and gouge the machined surface where it seals against the block. Also the casting behind the plug may be very close to the back of the plug. If it hits something solid, stop beating on it! You'll need to pry it out instead of knocking it in. Remember, cast iron is tough, but it will break! Cylinder liners are thin, any dent will cause disastrous failure! Don't be afraid of it, just use good judgment.
Now, going back with the new plug. Clean, scrape, and sand the machined hole to prep it for the new plug.
Getting a steel or brass plug to drive back in can be extremely difficult if you can't get a straight shot at it, and rarely will this be possible.
Rubber expandable plugs are OK, just somewhat temporary. If you use rubber, be sure the hole is completely dry, free of oil and coolant.
There is a copper expandable plug that works great. It requires a light tap to get in, then tighten the acorn nut to expand it. Completely permanent, lasts longer than a steel replacement.
If you use steel, brass, or copper expandable, seal it with some #2 Permatex or equivalent.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.