Trees certainly DO affect signals. So does the weather, hill-tops, etc. If you have a very strong signal to start with -it won't be noticeable. If weak to start with with - then it will cut in and out. With analog - that would mean seeing more snow in the screen. With digital - it means breaking up into pixels and/or disappearing completely.
The ability of the signal to travel have nothing to to with being digital or not. It's more about being VHF or UHF.
I've installed many TV antenna systems for people in problem areas.
#1 - you ought to download a signal-map for your property. Find out what is available and from what direction. Note that many TV stations changed locations when they changed to digital.
#2. Vertical antenna does not offer any improvement. The right antenna will and so will an antenna-mounted pre-amp. "Stacked" dual antennas in phase also offer some improvement for channels with big problems.
The main issue in your case is to find out what frequency your problem channel is on. The channel ID # means NOTHING. Digital channels now use "virtual channel IDs." You need to know the true RF channel and work from there. Can be low-VHF (used to called 2-6), high- VHF (used to be 7-13), or UHF (used to be 14 and up).
Very likely all you need is a $60 antenna and a $35 pre-amp and you'll be fine. I cannot imagine hiring someone to do it.
You can buy separate antennas and couple together. I do. I have a VHF-low, VHF-high, and UHF - all on one pole. Or you can just buy a big combo VHF-UHF antenna for simplicity. Winegard HD8200U is one of the most popular but it's big. Cost $116 and can be easily UPS shipped now. A few years ago - it had to be truck-shipped.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
